2pc F*CK IT EDITION emblem Badges Sticker Decal for Chevy Car Truck Universal
2pc Emblem Set. Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper. Prepare the emblem, making sure it's clean.
Future:3D Dome Surface100% brand new and high quality guaranteedDecorate your car charming luxury vividEasy to use and to operate at affordable pricesPerfect cover that is useful,helpful and so practicalAutomotive Adhesive for Long Lasting InstallationEasy to use and to operateNever fade & Water Proof3 1/8 x 1 1/4 or 80mm x 30mmActual emblem, not a thin sticker2pc Emblem Set
Installation Instructions 1. Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper.2.Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag.3.Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry.4.Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body lines. Use painter’s tape to make your guide lines.5.Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after Remove the backing tape from the adhesive.6.Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located properly.7.Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually takes 10 seconds..